Service Hotline
When the diodes are connected in series, what is the cut-off voltage and voltage distribution? Because when the diodes are connected in series in a static state, it depends on the stability. If there is no better effect, a hydraulic resistor must be used. When the cut-off voltage is greater than 1500 volts, a parallel resistor must also be added to separate the voltages. Although many beginners are very familiar with diodes and know their unidirectional conductivity, many of their uses in circuits are for rectification. In addition, it can also be seen that there are still many such uses in switching circuits.
The switching circuit characteristics of the combination of diode and transistor are still very good, that is, the switching diode is in the conducting state as long as there is forward voltage, and it is in the off state when there is reverse voltage. Using this feature, the switching circuit can be stroked, and the speed is faster. Moreover, the internal resistance is relatively small when it is turned on, and the resistance is very large when it is turned off. The effect of use is still very obvious. When used in the circuit, it can be seen that the inductor and capacitor are connected in parallel, which can form a resonant circuit. After the diode is connected in series, the access and disconnection of the capacitor can be controlled to form a switching circuit. In short, in the use of diodes, whether used in detection circuits or compensation circuits, they are very good.
Company phone number: +86-0755-83044319
Fax/FAX: +86-0755-83975897
Email: 1615456225@qq.com
QQ: 3518641314 Manager Li
QQ: 332496225 Manager Qiu
Address: Room 809, Building C, Zhantao Technology Building, No. 1079 Minzhi Avenue, Longhua New District, Shenzhen




粤公网安备44030002007346号